American made and molded in Mesa, Arizona, Quick Hooks allow for a new and inventive way to store and run cable safely within OSHA regulations. Quick Hooks eliminate tripping hazards by securely fastening cables to overhead structures.
The rugged patented design allows the Quick Hook to hold twice the weight as its competitors while remaining the same cost. Easily mounted and installed, Quick Hooks provide a safer working area for vehicles and pedestrian traffic alike.
Even when running multiple cables, the Quick Hook can still be turned to as a reliable solution. The Quick Hook holds up to 80 pounds of force. In high wattage areas the Quick Hook doesn’t waiver. This product is completely non-conductive. Quick Hook can either be hooked or screwed into place allowing it to fit in almost any overhead environment and moved easily to a different location if needed.
Quick Hooks abide by 15 different cord related OSHA regulations, keeping you well within compliance. Read more about those here.
How to use and optimize the Quick Hook
Quick Hook is a simple, user-friendly safety tool. One method for easy installation is to place the Quick Hook up on the place you wish to hang it, then carefully spread the opposite curved end sideways only slightly, enough to twist the wire or cables down inside the hook holding the cable in place. Once the cable, wire, or hose is already placed inside the hook, you can raise additional items into the air and lay them inside.
It’s wise to use a Quick Hook every 10 to 20 feet as to avoid slack and low hanging cable. Extra hooks should be implemented when going around corners.
Items suspended should be compatible with one another and should not create hazard. Electric cords carrying greater than 600V, should not be carried with other electric cords, except if allowed due to type of wire covering.
Check out the Quick Hook here.